My Printerbot Simple Metal does this "quirky" thing where it will stop printing halfway through a 4 hour print and just sit there.
Usually on the long prints, it will do it for 30-90 seconds, but often if I am printing a lot of parts at once, it just shuts down and disconnects.
Very annoying, and using Cura, there doesn't seem to be a way to start from the error, so i have to scrp the whole project.
I was using up the last of my bronze to make sure nothing went to waste and it stopped with moments left, maybe three lines were left out.. except I also printed a Teddy Bust in that batch of pieces and he got cut off as well.. Oh well, will try again in black, I suppose.
No comments:
Post a Comment