
Here's a picture of a remix of the Christmas boxes I printed last week. The bows and ribbons were separated and snap in (i had some issue snapping the bows, so I used some glue.
My favorite thing about this build is that I was able to print the top, bottom, ribbons and bow complete set in one full color. Then I can mismatch which goes where. I am not sure what to do with them - fill them with coins? A little bit of candy - They are small, maybe two snack packs of m&ms from Halloween would fit.
BASIC SETTINGS
Quality
Layer Height - 0.24
Shell Thickness - 1.2
Enable Retraction - X
Fill
Bottom/Top Thickness - 1
Fill Density - 20
Speed and Temperature
Print Speed - 50
Printing Temperature - 201
Bed temperature - 60
Support
Support Type - none
Platform Adhesion Type - raft
Filament
Diameter - 1.75
Flow - 89
Machine
Nozzle Size - 0.4
ADVANCED SETTINGS
Retraction
Speed - 40
Distance - 4.5
Quality
Initial Layer Thickness - 0.0
Initial Layer Line Width - 100
Cut Off Object Bottom - 0.0
Dual Extrusion Overlap - 0
Speed
Travel Speed - 150
Bottom Layer Speed - 20
Infill Speed - 0.0
Top/Bottom Speed - 0.0
Outer Shell Speed - 0.0
Inner Shell Speed - 0.0
Cool
Minimal Layer Time - 5
Enable Cooling Fan - X
EXPERT SETTINGS
Retraction
Minimum Travel - 1.5
Enable combing - all
Minimal Extrusion Before Retracting - 0.02
ZHop When Retracting - 0.0
Skirt
Line Count - 1
Start Distance - 3.0
Minimal Length - 150
Cool
Fan Full on at Height - 0.5
Fan Speed Min - 100
Fan Speed Max - 100
Minimum Speed - 10
Cool Head Lift -
Infill
Solid Infill Top - X
Solid Infill Bottom - X
Infill Overlap - 15
Infill Prints After Perimeters -
Black Magic
Spiralize the Outer Contour -
Only Follow Mesh Surface -
Brim
Brim Line Amount - 20
Raft
Extra Margin - 5.0
Line Spacing - 3.0
Base Thickness - 0.3
Base Line Width - 1.0
Interface Thickness - 0.27
Interface Line Width - 0.4
Airgap - 0.0
First Layer Airgap - 0.26
Surface Layers - 1
Surface Layer Thickness - 0.27
Surface Layer Line Width - 0.4
Fix Horrible
Combine Everything (Type A) - X
Combine Everything (Type B) -
Keep Open Faces -
Extensive Stitching -
No comments:
Post a Comment