Sunday, December 4, 2016

Cosmic Encounters Updates


I have been busily printing, adjusting, scratching my head.

Like I've said, I don't have the expansions, So I'm not sure how great this solution will be. I have been printing out the pieces, just a little time consuming as my printer is too small to print more than one piece at a time, including the lids!

I also might need to find a different solution for the Alien cards. I can fit the holder on my bed, but once it starts closing the spaces on the top layer, everything starts falling apart and the print actually looks distorted., the plastic widens, and become loosely melted together. I did three attempts - the first attempt died when my power died. The second had the horrible issue with the layers, and the third I stopped when it started having the same issues, even though I slowed the speed.

I probably need to print it without the holes, or make the holes smaller. I have noticed that the Printrbot doesn't like fine detail when it's high up.

No comments:

Post a Comment